ACT500 /01(E_F_S_C) 13/6/03 11:08 Page 1 english supplied accessories controls controls / accessories remote control AY3781 ( see figure 2 ) 1 p ...........................3.5 mm headphone plug to connect to headphones socket 2 hold .....................locks all buttons 3 stop......................stops playback and switches the set off 4 5 / 6..................skips and searches forward / backward tracks 5 +/- ........................adjusts the volume 6 2; ........................switches the set on, starts playback and interrupts playback accessories / power supply hand strap / waist pack AY3293 wear your cd player during sport activity by securing it to the supplied hand strap / waist pack. 1 open the strap enclosure on the back of the hand strap / waist pack and slide the cd player inside. make sure the headphone / remote socket is aligned to the socket hole. power supply / general information ECO-PLUS NiMH battery information (for versions supplied with the rechargeable ECO-PLUS NiMH battery AY 3363) recharging works only on players supplied with the rechargeable ECO-PLUS NiMH battery AY 3363. recharging the ECO-PLUS NiMH battery on board 1 insert the rechargeable ECO-PLUS NiMH battery AY 3363. 2 connect the mains adapter to the DC socket of the player and then to the wall socket. y is pulsing. · recharging stops after a maximum of 7 hours, or when you start playback. 3 when the battery is fully recharged, appears in the display. general information / cd play cd player and cd handling · do not touch the lens A of the cd player. · do not expose the unit, batteries or cds to humidity, rain, sand or excessive heat (caused by heating equipment or direct sunlight). · you can clean the cd player with a soft, slightly dampened, lint-free cloth. do not use any cleaning agents as they may have a corrosive effect. · to clean the cd, wipe it in a straight line from the center toward the edge using a soft, lint-free cloth. a cleaning agent may damage the disc! never write on a cd or attach a sticker to it. · the lens may cloud over when the unit is moved suddenly from cold to warm surroundings. playing a cd is not possible then. leave the cd player in a warm environment until the moisture has evaporated. · active mobile phones in the vicinity of the cd player may cause malfunctions. · avoid dropping the unit as this may cause damage. · do not position the set on top of other equipment that might heat it up (e.g. receiver or amplifier) · apparatus shall not be exposed to dripping or splashing. · do not place any sources of danger on the apparatus (e.g. liquid filled objects, lighted candles). cd play / features playing a cd this cd-player can play all kinds of audio discs such as cd-recordables and cd-rewritables. do not try to play a cd-rom, CDi, VCD, DVD or computer cd. features selecting a track and searching selecting a track during playback · briefly press 5 or 6 once or several times to skip to the current, previous or next track. y playback continues with the selected track, and the track's number is displayed. selecting a track when playback is stopped 1 briefly press 5 or 6 once or several times to select the desired track. the track number is displayed. 2 press 2; to start cd play. y playback starts with the selected track. searching for a passage during playback 1 keep 5 or 6 pressed to find a particular passage in a backward or forward direction. y searching starts while playback continues at low volume. after 2 seconds the search speeds up. 2 release the button when you reach the desired passage. y playback continues from this position. notes: ­ if the player is in mode (see mode chapter), searching is not possible. ­ in shuffle, shuffle repeat or repeat mode (see mode chapter), searching is only possible within the particular track. features / troubleshooting resume and hold you can interrupt playback and continue (even after an extended period of time) from the position where playback stopped (resume) and you can lock all buttons of the set so that no action will be executed (hold). use the off­resume­hold slider for these functions. resume ­ continuing from where you have stopped 1 switch the slider to resume during playback to activate resume. y resume is shown. 2 press 9 whenever you want to stop playback. 3 press 2; whenever you want to resume playback. y resume is shown and playback continues from where you have stopped. · to deactivate resume, switch the slider to off. y resume goes off. hold ­ locking all buttons you can lock the buttons of the set by switching the slider to hold. now, when a key is pressed, no action will be executed. this is of use, for example, when transporting the player in a bag. with hold activated, you can avoid accidental activation of other functions. 1 switch the slider to hold (or switch hold on the remote control) to activate hold. y all buttons are locked is shown when you press any button. indicator turns red and flashes. if the set is switched off, will be shown only when 2; is pressed. 2 to deactivate hold, switch the slider to off. (or switch hold on the remote control) note: if you deactivate hold by switching the slider to resume, you will be activating the resume function. AUSTRALIA - Philips 3 years Manufacturers Warranty for Australia only These warranty conditions are valid for the following consumer electronics products: Colour Televisions,Video Cassette Recorders, CD Players and Recorders, DVD Players and Recorders,Audio Systems and Portable Audio. The benefits given to the purchaser by this warranty are in addition to all other rights and remedies which the purchaser has in respect of the product under the Trade Practices Act or other Commonwealth or State Law. Philips Consumer Electronics warrants its products to the purchaser as follows and subject to the stated conditions. d) Product failures caused by misuse, neglect, accidental breakage, transit damage, inexpert repairs or modification by un-authorised persons, external fires, lightning strikes, floods, vermin infestation or liquid spillage. e) Cleaning of video or audio heads. f) Inadequate receiving antennae. g) Replacement of worn or used batteries or other consumables. h) Consumer products used in commercial applications (This warranty is limited to 3 months only). i) Second hand products. The conditions contained in this warranty card replace and override the provision of the Philips World-Wide Guarantee for products purchased in Australia and used in Australia. Philips Authorised Service Centres Service is provided through 200 accredited Authorised Service Centres throughout Australia. For direct contact with your nearest recommended Authorised Service Centre in major cities: Adelaide Brisbane Canberra Geelong Gold Coast Hobart Launceston Melbourne Newcastle Perth Sydney Wollongong ­ 1 x headphones, HJ050 ­ 1 x remote control, AY3781 ­ 1 x AC/DC adapter, AY3170 ­ 2 x rechargeable batteries, AY3363 ­ 1 x hand strap / waist pack, AY3293 controls ( see figure 1 ) psa[cd portable cd player 1 mode ...................selects the different playing possibilities: shuffle, shuffle repeat, repeat and 2 eq .........................switches the bass enhancement on and off. this button also switches acoustic feedback (the beep) on/off when it is pressed for more than 2 seconds 3 esp ......................toggle to select between the battery powersave mode and electronic skip protection (esp). esp ensures continuous cd playback regardless of vibrations and shocks 4 p ...........................3.5 mm headphone socket, socket to connect the player to another audio input of an additional appliance, remote control socket 5 +/- ........................adjusts the volume 6 5 .........................skips and searches cd tracks backwards 7 indicator.............lights up : red (battery low / power down) , green (power up), orange (pause mode) 8 2; ........................switches the player on, starts or pauses cd play 9 9...........................stops cd play, switches the player off 0 6 .........................skips and searches cd tracks forwards ! DC ........................socket for external power supply @ off.........................switches resume and hold off resume................stores the last position of a cd track played hold .....................locks all buttons # .................opens the cd lids 1 push the slider to open the player. 2 insert an audio cd, printed side up, by pressing the cd onto the hub. 3 close the player by pressing the lid down. 4 press 2; to switch the player on and start playback. y the current track number and elapsed playing time are displayed. indicator lights up green. · you can pause playback by pressing 2;. y the time at which playback was paused starts flashing. indicator turns orange and flashes. · you can continue playback by pressing 2; again. 5 press 9 to stop playback. y the total number of tracks and the total playing time of the cd are displayed. 6 press 9 again to switch the player off. indicator lights up red and gradually turns off. · to remove the cd, hold it by its edge and press the hub gently while lifting the cd. note: if there is no activity, the set will automatically switch off after a while to save energy. 3 YEARS free Repair Service Colour Televisions, CD Players and Recorders, DVD Players and Recorders and Audio Systems. 3 YEARS free Replacement ­ at your Retailer All Portable Audio products and all Video Cassette recorders (VCR's) only. Conditions of Repair Warranty the model and serial numbers are located inside the cd door. 2 thread the strap. 1. All claims for warranty service should be made to your nearest Philips Authorised Service Centre. Reasonable evidence of date of purchase must be provided. connecting the remote control use only the AY 3781 remote control. 1 2 3 4 5 press 9 on the set twice to switch off the set. firmly connect the remote control to p on the set. firmly connect the headphones to the plug on the remote control. on the remote control keep 2; pressed for 1 second to switch on the set and to start playback. adjust the volume and sound on the psa and your remote control. 3 position your hand and adjust the strap until the fit is snug and comfortable. 2. This warranty extends only to defects in material or workmanship occurring under normal use of the product when operated in accordance with the instructions. 3. This warranty applies for original purchase only. It is not transferable if sold. notes: ­ it is normal for the batteries to become warm during recharging. ­ if the batteries become too warm, recharging will be interrupted for approximately 30 minutes and is displayed. ­ to ensure proper recharging on board, take care that contacts are clean. ­ use only the ECO-PLUS NiMH battery AY 3363. 4. Home service within the normal service area of one of our Authorised Service Centres will only be provided for television receivers with screen size 48 cm and above. All other products are to be taken or sent to the workshop of your nearest Authorised Service Centre (at Consumer's expense). or to find the location of your nearest recommended Authorised Service Centre outside the above cities please call our National Service telephone number: 1300 361 392 Please record the following information for your records and keep in a safe place. Model number:.................................................... Serial number:.................................................... Date of purchase:.................................................... Retailer:.................................................... We recommend you retain your purchase receipt to assist in any warranty claim. 5. This Manufacturers Warranty is limited to 3 months for above listed Consumer Electronics products if used in commercial applications. handling instructions · recharging already charged or half-charged batteries will shorten their lifetime. we therefore recommend that you let the rechargeable ECO-PLUS NiMH battery run till it is completely empty before you recharge it. · to avoid a short circuit, do not let the battery touch any metal object. · if the battery becomes empty soon after recharging, then either its contacts are dirty or it has reached the end of its lifetime. 6. Philips may, at its discretion choose to replace rather than repair any product covered by this warranty. 7. This Manufacturers Warranty is neither transferable nor valid in countries other than Australia. This warranty does not cover: a) Mileage or travelling time, pickup or delivery, installations and cost of insurance. b) Mileage or travel outside the normal service area covered by selected Authorised Service Centre. c) Service costs arising from failure to correctly adjust the controls of the product or to observe the instructions, or inspections that reveal that the product is in normal working order. IMPORTANT modifications not authorized by the ma ...