PUB. DIM-462 DIGITAL VIDEO CAMCORDER Instruction Manual CAMESCOPE ET LECTEUR VIDEO NUMERIQUES ENGLISH E Mode d'emploi VIDEOCAMARA Y GRABADORA DIGITAL FRANÇAIS F Manual de Instrucciones ESPAÑOL Es Mini Digital Video Cassette NTSC PUB. DIM-462 Important Usage Instructions WARNING: E WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE. TO REDUCE THE RISK OF ELECTRIC SHOCK AND TO REDUCE ANNOYING INTERFERENCE, USE THE RECOMMENDED ACCESSORIES ONLY. COPYRIGHT WARNING: Unauthorized recording of copyrighted materials may infringe on the rights of copyright owners and be contrary to copyright laws. Digital Video Camcorder, GL2 systems This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and use in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. · Consult the dealer or an experienced radio/TV technician for help. Use of shielded cable is required to comply with class B limits in Subpart B of Part 15 of FCC Rules. Do not make any changes or modifications to the equipment unless otherwise specified in the manual. If such changes or modifications should be made, you could be required to stop operation of the equipment. Canon U.S.A. Inc. One Canon Plaza, Lake Success, NY 11042, U.S.A. Tel No. (516)328-5600 Introduction CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT. Important Warning CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure, that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point, within an equilateral triangle, is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. 2 IMPORTANT SAFETY INSTRUCTIONS In these safety instructions the word "product" refers to the Canon Digital Video Camcorder GL2 and all its accessories. 1. Read Instructions -- All the safety and operating instructions should be read before the product is operated. 2. Retain Instructions -- The safety and operating instructions should be retained for future reference. 3. Heed Warnings -- All warnings on the product and in the operating instructions should be adhered to. 4. Follow Instructions -- All operating and maintenance instructions should be followed. 5. Cleaning -- Unplug this product from the wall outlet before cleaning. Do not use liquid or aerosol cleaners. The product should be cleaned only as recommended in this manual. 6. Accessories -- Do not use accessories not recommended in this manual as they may be hazardous. 7. Avoid magnetic or electric fields -- Do not use the camera close to TV transmitters, portable communication devices or other sources of electric or magnetic radiation. They may cause picture interference, or permanently damage the camera. 8. Water and Moisture -- Hazard of electric shock -- Do not use this product near water or in rainy/moist situations. GROUND CLAMP 11. Polarization -- The CA-920 Compact Power Adapter is equipped with a polarized 2-prong plug (a plug having one blade wider than the other). The 2-prong polarized plug will fit into the power outlet only one way. This is a safety feature. If you are unable to insert the plug fully into the outlet, try reversing the plug. If the plug still fails to fit, contact your electrician to replace your obsolete outlet. Do not defeat the safety purpose of the polarized plug. 12. Power Cord Protection -- Power cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them. Pay particular attention to plugs and the point from which the cords exit the product. 13. Outdoor Antenna Grounding -- If an outside antenna is connected to the product, be sure the antenna is grounded so as to provide some protection against voltage surges and built-up static charges. Section 810 of the National Electrical Code, ANSI / NFPA No. 70--1984, provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna discharge unit, connection to grounding electrodes, and requirements for the grounding electrode. See figure 1. E Introduction Fig. 1 EXAMPLE OF ANTENNA GROUNDING AS PER NATIONAL ELECTRICAL CODE ANTENNA LEAD IN WIRE 9. Placing or Moving -- Do not place on an unstable cart, stand, tripod, bracket or table. The product may fall, causing serious injury to a child or adult, and serious damage to the product. A product and cart combination should be moved with care. Quick stops, excessive force, and uneven surfaces may cause the product and cart combination to overturn. 10. Power Sources -- The CA-920 Compact Power Adapter should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power supply to your home, consult your product dealer or local power company. Regarding other power sources such as battery power, refer to instructions in this manual. ANTENNA DISCHARGE UNIT (NEC SECTION 810-20) ELECTRIC SERVICE EQUIPMENT GROUNDING CONDUCTORS (NEC SECTION 810-21) GROUND CLAMPS POWER SERVICE GROUNDING ELECTRODE SYSTEM (NEC ART 250. PART H) NEC - NATIONAL ELECTRICAL CODE 14. Lightning -- For added protection of this product during a lightning storm, or when it is left unattended and unused for long periods of time, disconnect it from the wall outlet and disconnect the antenna. This will prevent damage to the product due to lightning and power-line surges. 3 E 15. Overloading -- Do not overload wall outlets and extension cords as this can result in a risk of fire or electric shock. 16. Objects and Liquid Entry -- Never push objects of any kind into this product through openings as they may touch dangerous voltage points or short out parts that could result in a fire or electric shock. Be careful not to spill liquid of any kind onto the product. 17. Servicing -- Do not attempt to service this product yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel. 18. Damage Requiring Service -- Disconnect this product from the wall outlet and all power sources including battery, and refer servicing to qualified service personnel under the following conditions: a. When the power-supply cord or plug is damaged. b. If any liquid has been spilled onto, or objects have fallen into, the product. c. If the product has been exposed to rain or water. d. If the product does not operate normally even if you follow the operating instructions. Adjust only those controls that are covered by the operation instructions. Improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to its normal operation. e. If the product has been dropped or the cabinet has been damaged. f. When the product exhibits a distinct change in performance. This indicates a need for service. 19. Replacement Parts -- When replacement parts are required, be sure the service technician has used replacement parts that are specified by Canon or that have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock or other hazards. 20. Safety Check -- Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in safe operating order. Introduction 4 Operating Steps and Reference Guide Your camcorder is supplied with two manuals: the "Digital Video Camcorder GL2 Instruction Manual" and the "Digital Video Solution Disk Instruction Manual". E Digital Video Camcorder GL2 Instruction Manual Preparations Recording Playback Introduction Editing Using the Memory Card Digital Video Solution Disk Instruction Manual Installing the Software Connecting the Camcorder to a Computer Downloading the Still Image to a Computer 5 Contents E Introduction Important Usage Instructions ........................ Important Safety Instructions ........................ Operating Steps and Reference Guide .......... Thank You For Choosing a Canon ................ Introducing the GL2 ...................................... 2 3 5 8 9 Manual Adjustments Adjusting the Exposure Manually ................ 76 Adjusting the Focus Manually .................... 79 Setting the White Balance .......................... 80 Using the AE Shift ...................................... 82 Using the Custom Preset ............................ 83 Using the Zebra Pattern .............................. 85 Recording PC Screens and Other Screens Using CLEAR SCAN.................................... 86 Recording the Viewfinder Information..........86 Preparations Finding Your Way Around the GL2.............. Preparing the Camcorder ............................ Powering the Camcorder ............................ Loading a Cassette...................................... Using the Menus ........................................ Using the Wireless Controller/Tally Lamp .... Setting the Date and Time .......................... 10 14 16 18 20 29 32 Playback Playing Back a Tape .................................... 87 Displaying Date, Time and Camcorder Data (Data Code) ...................................... 90 Searching the Tape (Photo Search/Date Search/Index Search) .................................. 93 Returning to a Pre-Marked Position (Zero Set Memory) .................................... 94 Connections for Playback on a TV Screen.... 95 Introduction Recording Basic Recording .......................................... Tips for Making Better Videos .................... Zooming .................................................... Using the LCD Screen ................................ Turning the Optical Image Stabilizer Off ...... Using the ND Filter...................................... Recording Still Images onto a Tape.............. Selecting the Movie Mode (Normal/Frame).. Searching and Reviewing While Recording .. Using the Various Recording Programs ........ Audio Recording ........................................ Using the Custom Key ................................ Using Digital Effects .................................... Using the Color Bars .................................. Using a Canon Speedlite for Flash Photography (Optional) .............................. Recording with the Interval Timer .............. Recording with the Self-Timer .................... Using the DV Control.................................. Using the VL-3 Video Light (Optional) ........ Using the DM-50 Microphone (Optional) .... Using the MA-300 Microphone Adapter (Optional) .................................................. 35 40 42 43 46 47 48 50 51 52 56 58 62 67 68 69 71 72 73 74 75 Editing Editing to a VCR ........................................ 97 Dubbing to/from a Tape with Digital Video Equipment ...................................... 99 Recording from a VCR, TV or Analog Camcorder (Analog Line-in) .................... 101 Digitally Outputting Analog Video and Audio Signals (Analog-Digital Converter).. 103 Recording Over Existing Scenes (AV Insert Editing) .................................... 105 Audio Dubbing ........................................ 108 Setting the Audio Mix .............................. 111 Connecting to a PC Using a DV Cable ...... ...