Indicar todas las referencias
	Ay denos a encontrar los manuales
	Añadir un manual
	Registrar Conectarse
	Aada la herramienta de b squeda de manuales en su sitio Internet o foro
	Preguntas Frecuentes
	Contacto Diplodocs equipo
MANUALES POR CATEGORIAS Electrodomesticos Televisor & Sonido Automóvil & Moto Telefonica Informatica Photo & Video Musica Material de deporte Ferreteria, Casa & Jardin Juegos de video & Software Joyas & Reloj Bebe & Juegos Belleza & Salud Otros

For assistance and information, WI toll free I-800-BUY-AIWA. (United States and Puerto Rico) 8Z-CL7-901 -01 980922APA-X9 m EiiG!TAL dugu "cl o !3 Akll)lQ COMPACT Read the Operating Instructions carefully and completely before operating the unit. Be sure to keep the Operating Instructions for future reference. All warnings and cautions in the Operating instructions and on the unit should be strictly followed, as well as the safety suggestions below. Installation 1 Water and moisture -- Do not use this unit near water, such as near a bathtub, washbowl, swimming pool, or the like. 2 Heat -- Do not use this unit near sources of heat, including heating vents, stoves, or other appliances that generate heat. It also should not be placed in temperatures less than 5°C (41 `F) or greater than 35°C (95°F). 3 Mounting surface -- Place the unit on a flat, even surface. 4 Ventilation -- The unit should be situated with adequate, space around it so that proper heat ventilation is assured. Allow 10 cm (4 in.) clearance from the rear and the top of the unit, and 5 cm (2 in,) from the each side. - Do not place the unit on a bed, rug, or similar surface that may block the ventilation openings. - Do not install the unit in a bookcase, cabinet, or airtight rack where ventilation may be impeded. 5 Objects and liquid entry -- Take care that objects or liquids do not get inside the unit through the ventilation openings. 6 Carts and stands -- When placed or mounted on a stand or cart, the unit should be moved with care. Quick stops, excessive force, and m A&* $ uneven surfaces may cause the unit or earl to overtur_nor fall. 7 Condensation -- Moisture may form on the CD pickup lens when: - The unit is moved from a cold spot to a warm spot - The heating system has just been turned on - The unit is used in a very humid room - The unit is cooled by an air conditioner When this unit has condensation inside, it may not function normally. Should this occur, leave the unit for a few hours, then try to operate again. 8 Wall or ceiling mounting -- The unit should not be mounted on a wall or c~ling, unless specified in the Operating instructions. Electric Power 1 Power sources -- Connect this unit only to power sources specified in the Operating Instructions, and as marked on the unit. 2 Polarization --As a safety feature, some units are equipped with polarized AC power plugs which can only be inserted one way into a power outlet. If it is difficult or impossible to insert the AC power plug into an outlet, turn the plug over and try again. If it still does not easily insert into the outlet, please call a qualified service technician to service or replace the outlet. To avoid defeating the safety feature of the polarized plug, do not force it into a power outlet. 3 AC power cord - When disconnecting the AC power cord, pull out by the AC power plug. Do not pull the cord itself. - Never handle the AC power plug with wet hands, as this could result in fire or shock. - Power cord should be routed to avoid being severely bent, pinched, or walked upon. Pay particular attention to the cord from the unit to the power socket. - Avoid overloading AC power plugs and extension cords beyond their capacity, as this could result in fire or shock. "CAUTION:TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL." 1 ENGLISH 4 Extension cord -- To help prevent electric shock, do not use a polarized AC power plug with an extension cord, receptacle, or other outlet unless the polarized plug can be completely inserted to prevent exposure (ofthe blades of the plug. 5 When not in use -- Unplug the AC power plug from the power socket if the unit will not be used for several months or more. When the cord is plugged in, a small amount of current continues to flow to the unit, even when the power is turned off. Outdoor Antenna 1 Power lines -- When connecting an outdoor antenna, make sure it is located away from power lines. 2 Outdoor antenna grounding -- Be sure the antenna system is properly grounded to provide protection against unexpected voltage surges or static electricity build-up. Article 810 of the National Electrical Code, AN S1/NFPA70, provides information on proper grounding of the mast, supporting structure, and the lead-in wire to the antenna discharge unit, as well as the size of the grounding unit, connection to grounding terminals, and requirements for grounding terminals. PRECAUTIONS .................................................................,, 1 PREPARATIONS ---- CONNECTIONS ................................................................. 3 REMOTE CONTROL ...........................................................5 BEFORE OPERATION ............................................m ...........5 SOUND AUDIO ADJUSTMENTS .................................................... 6 GRAPHIC EQUALIZER ......................................................6 RADIO RECEPTION MANUAL TUNING ...............................................................7 PRESETTING STATIONS ...................................................8 CD PLAYING Antenna Grounding According to the National Electrical Code Ti=I --1 Iv I NEC-NATIONAL ELECTRICAL CODE -- ELECTRODE ! -------- BASIC OPERATIONS 9 PROGRAMMED PLAY ..................................................... 10 . . . . . . . ..m . . . . .. . . .. . . .. . . . .. . . . .. . . .. . . . . .. . . .. . . .. . . .. ANTENNA LEAD IN WIRE TAPE PLAYBACK BASIC OPERATIONS ....................................................... 11 RECORDING ,,.ti-..- DISCHARGE UNIT FION 810-20) BASIC RECORDING ........................................................ 12 13 Al EDIT RECORDING PROGRAMMED EDIT RECORDING ............................... 14 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..u ........ CLOCK AND TIMER . . . . . . . . . . . . . . . . . . . . . . . . . ..m . . . . . . . . . . . . . ..m . . . . .. . . -- m 15 SETTING THE CLOCK SETTING THE SLEEP TIMER ......................................... '15 SETTING THE TIMER .............................................u ........ 16 OTHER CONNECTIONS Maintenance Clean the unit only as recommended in the Operating instructions. Damaae Reauirina Service Have the units serviced by a qualified service technician if: - The AC power cord or plug has been damaged - Foreign objects or liquid have gotten inside the unit - The unit has been exposed to rain or water - The unit does not seem to operate normally - The unit exhibits a marked change in performance - The unit has been dropped, or the cabinet has been damaged YOURSELF. DO NOT ATTEMPT TO SERVICE THE UNIT CONNECTING OPTIONAL EQUIPMENT ....................... 17 LISTENING TO EXTERNAL SOURCES ......................... 17 GENERAL CARE AND MAINTENANCE ........................................... 18 TROUBLESHOOTING GUIDE ......................................... '18 SPECIFICATIONS ............................................................ '19 PARTS INDEX .................................................................. :20 Owner's record For your convenience, record the model number and serial number (you will find them on the rear of your set) in the space provided below. Please refer to them when you contact your Aiwa dealer in case of difficulty. I Model No. \ Serial No. (Lot No.) I I XR-M33u I I ENGLISH 2 Before connecting the AC cord The rated voltage of your unit shown on the rear panel is 120 V AC. Check that the rated voltage matches your local voltage. Check your system and accessories IMPORTANT " Connect the speakers, antennas, and all optional equipment first. Then connect the AC cord. q There are no differences between the front speakers. Both speakers can be connected as L (Left) or R (Right) 7 Connect the speaker cord to the main unit. XR-M33 Compact disc stereo cassette receiver Speakers (L, R) The speaker cord with the white stripe should be connected to 0 terminal and the black cord to O terminal. Remote control FM antenna AM antenna Operating Instructions, etc. 2 FM antenna nna Ri Speaker cord +3 3 ENGLISH 2 Connect the supplied antennas. Connect the FM antenna to FM 75 Q terminals and the AM antenna to AM LOC~Pterminals. T `Mantenna AM LOOP antenna For better FM reception, use of an outdoor antenna recommended, Connect the outdoor antenna to FM 75 Q terminals. is ~oo? prd 3 Connect the AC cord to an AC outlet. -- To connect other optional equipment+ page 17 To stand the AM looIp antenna on a surface Fix the claw to the slot, 1 C ) L -/ J To position the antennas FM feeder antenna: Extend this antenna horizontally in a T-shape and fix its ends to the wall. AM loop antenna: Position for the best reception. q q Do not connect any speakers to the unit other than the supplied ones. Be sure to connect the speaker cords correctly. Improper connections can cause short circuits in SPEAKERS terminals. q q q q Do not leave objects generating magnetism, such as credit cards, near the speakers, as these objects may be damaged. Do not bring the FM antenna near metal objects or curtain rails. Do not bring the AM i~ntenna near other optional equipment, the stereo system itself, the AC cord or speaker cords, since noise will be picked up. Do not unwind the AM antenna wire. ENGLISH 4 Inserting batteries Detach the battery cover on the rear of the remote control and insert two size AA (R6) batteries. POWER (!) STANDBY/ ON Remote sensor Function -- buttons DEMO/ECO AA `(R6) When to replace the batteries The maximum operational distance between the remote control and the sensor on the main unit should be approximately 5 meters (16 feet). When this distance decreases, replace the batteries with new ones. Using the remote control The instructions in this manual refer mainly to the buttons on the main unit. Buttons on the remote control with the same names as those on the main unit can be used as well. To use FUNCTION on the remote control The FUNCTION substitutes for the function buttons (TAPE, TUNER, AUWVIDEO, CD) on the main unit. Each time FUNCTION is pressed while power is on, the next function is selected cyclically. * PLAY on the remote control The function is the same as that of

DIR/ PRESET during power on. To reset the interval, repeat this procedure. 1 Press TUNER/BAND desired band. repeatedly to select the When the AM tuning interval is changed, all preset stations are cleared. The preset stations have to be set again. m n When TUNER/BAND is pressed while the power is off, the previously tuned station will be played (Direct Play Function). To select a band with the remote control Press BAND repeatedly. 2 Press + or B to select a station. Each time the button is pressed, the frequency changes. When a station is received, "TUNE is displayed for 2 seconds. During FM stereo reception, "[lI@Jl]" is displayed. To search for a station quickly (Auto Search) Keep + or > pressed until the frequency starts to change rapidly. After tuning in to a station, the search stops. To stop the Auto Search manually, press + or -. q The Auto Search may not stop at stations with very weak signals. 7 ENGLISH Use the remote control to select the preset number directly. 1 Press BAND to select a band. I l"------------ I 2 Press numbered 7 +- DIR/ PRESET 1 2 buttons O-9 and +1 O to select a preset number. 0-9,+1o BAND Example: To select preset number 20, press +10, +10 and O. To select preset number 15, press +10 and 5. Selecting a preset number on the main unit Press TUNER/BAND to select a band. Then, press ~> DllR/ PRESET repeatedly. Each time